Jenzen ATS cab pics Copyright 2013 © Troels Gravesen |
BACK TO JENZEN ATS PAGE The rough and finished cabs ready for a little filler here and there - and a lot of sanding before spray paint. Jenzen ATS tweeter cabs Rounding of tweeter hole is pure aestetics. Jenzen ATS mid cabs Assembling the mid cabs was more than tricky due to sloped panels. Had to make a router guide some 1 meter long for making the mid cab ad-on side panels. Gluing even more difficult. I used three nails to keep them in place before brackets could be applied. After settling the nails were removed and holes had some filler. Jenzen ATS bass cabs Bass cab rear holding the crossover, crossover cover (8 mm MDF) and terminal bar. BACK TO JENZEN ATS PAGE To top of this page |