ScanSpeak 3WC-C, built by Mark
Copyright 2018 © Troels Gravesen

Hello Mr Gravesen,
Thank you for your help on building this speaker project. I would not have been able to do this without your website. The build had a few challenges. The routing took longer than expected. On the first attempt all went well until I noticed two left speakers had been cut. There was enough black HDF remaining to make a new front panel. I was lucky. In my location the HDF is expensive. I used the black HDF on the fillets to attach the front panel. This didn't seem like a great choice when attaching the front panel. The HDF did not seem to have the ability to hold a screw well. In the picture you can see I drilled the HDF out and filled the holes with epoxy. This held the screws and the front panel seems to be very secure.  I am 100% satisfied with the result. The speakers have been completed and in place for almost six months. Thank you again for all of your help.
Mark
California,USA